Change of microstructure of Nb microalloyed steel at start of the plastic flow during the cold deformation

Znanstveni rad - Izvorni znanstveni rad

• Autor: Ljerka Slokar Benić
• Autor: Stoja Rešković
• Autor: Marijan Marciuš
• Autor: Tin Brlić
• Autorova ustanova: Sveučilište u Zagrebu; Metalurški fakultet
• Znanstveno / umjetničko područje, polje i grana: TEHNIČKE ZNANOSTI; Metalurgija

Sažetak (engleski)

Microstructure has significant impact on the properties and behavior of materials, so it is a subject of intensive investigation nowdays. In this paper, special attention is paid to study on the beginning of the plastic material flow in Nb microalloyed steel during the cold deformation. Specific behavior of this steel can present a significant problem during the metalworking in terms of inhomogeneous deformations appearance. Due to many available methods now it is possible to observe what is happening during the deformation of certain material. Hence, investigation of material flow and stress distribution in deformation zone is growing up today. Therefore, the aim of this work was to establish the change of microstructure of low carbon steel microalloyed with niobium at start of the plastic flow during the cold deformation. For that purpose Nb microalloyed steel was hot rolled into strip and then static tensile test was carried out. Thermography method was used to study the changes of temperature during the deformation. Microstructure before and after deformation was observed by scanning electron microscope. These investigations showed the fine grained ferrite -pearlitic microstructure and its significant changes at start of the plastic flow during the cold deformation

• Ključne riječi (engleski): Cold Deformation, Microstructure, Niobium Microalloyed steel
• Jezik: engleski
• Vrsta publikacije: Znanstveni rad - Izvorni znanstveni rad
• Status objave: Objavljen
• Vrsta recenzije: Recenziran - međunarodna recenzija
• Verzija publikacije: Objavljena verzija rada (izdavačev PDF)
• Naslov časopisa: International Journal of Mechanical and Production Engineering
• Brojčani podaci: vol. 7, br. 12, str. 120-122
• p-ISSN: 2320-2092
• e-ISSN: 2321-2071
• URN:NBN: urn:nbn:hr:115:072136
• Datum objave publikacije: 2019-12
• Projekt: Šifra: IP-2016-06-1270; Naziv (hrvatski): Istraživanja početka plastičnog toka metala kod hladne deformacije; Kratica: MFSRIP062016; Voditelj: Stoja Rešković; Pravna nadležnost: Hrvatska; Financijer: HRZZ; Linija financiranja: IP
• URL dokumenta: http://iraj.in/journal/IJMPE/volume.php?volume_id=621
• Vrsta resursa: Tekst
• Prava pristupa: Otvoreni pristup
• Datum i vrijeme pohrane: 2020-02-25 10:07:15